Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for T-Mark T1-2
Summary of Contents for T-Mark T1-2
- Page 1 Vehicle GPS Tracker User Manual Model:T1-2 Please read the manuals carefully before you use it, so as to get the correct installation and quick online activation. If the appearance and color of the product are changed, the object will prevail.
-
Page 2: Technical Parameter
1. Technical parameter 1. GSM：850/900/1800/1900MHz 2. GPRS：Class12,TCP/IP 3. Working Voltage：9~36V 4. Working Current：≈22mA (12vDC) 5. Working Current：≈12mA (24vDC) 6. GPS Fixed Time：Cold start≈38s（Open sky） Hot start≈2s（Open sky） 7. GPS Precision：10m（2D RM） 8. Working Temperature：-20℃～+70℃ 9. Working Humidity：20%～80%RH 10. Measurement：50.0 L×29.0 W×39.0 H mm... -
Page 3: Appearance Diagram
2. Appearance diagram 3. Installation method of SIM card 3.1 Preparation before installation 3.2 Product inspection: open the package to check whether the device model is correct and whether the accessories are complete. Otherwise, please contact your distributor 3.3 SIM card selection: the device needs to insert a GSM band... - Page 4 SIM card. Please refer to the dealer's opinion for the selection of GSM card 3.4 Installation: first open the back cover, into the SIM card (middle card), then close the back cover. (as shown in the figure below)
- Page 5 3.5 At this time, the external 9-36v power supply can be connected. Note: the terminal GSM card needs to open the GPRS function, and ensure that the terminal GSM card has the tariff; If your GSM is enabled and requires PIN code input, please refer to your mobile phone user manual to turn off the PIN code input function.
-
Page 6: User Instruction
the device runs out, and the terminal shuts down after power off. User instruction (1) CENTER Command Parameter Sample CENTER,A,number# CENTER,A,130XXXX# CENTER,D# CENTER,D# 1) center number can be used to send short message instructions to restore the Description factory settings 2) the central number is also the function of SMS and telephone reception. - Page 7 Must set the center number and receiving number. Feedback SET VIBRATION OK! (3) TIMER Command Parameter Sample Format TIMER,Upload time# TIMER,30# 1 time range: 10~180 seconds; 2 the default is 10 seconds to upload! Description 3 timing boot and deep sleep mode has been dormant, upload interval is invalid.
- Page 8 1)RELAY control the start and closeness of the relay,in order to control the circle 2) Only the center number can operate. 3）the device only cut off the oil circuit on the condition of the driving speed below 20KM/H and in Positioning state. Description 4)If it currently do not meet the condition, the device will reply “Do not allow to cut off the oil...
- Page 9 This instruction is used to set up the monitor, range 0~1, default is closed; If you need to turn on the sample 1 to send the instruction, if you need to close the case by case 2; Description Set the number must be the central number;...
- Page 10 (6) STATUS Command Parameter Sample Format STATUS# STATUS# This command is used to query devices Description some working condition. BATTERY:100% Battery voltage GSM:HIGH GSM Singal GPS:FIXED HIGH GPS Status Feedback RELAYER:DISABLED Oil Status ACC:ON ACC Status CHARGER:NORMAL Power Status (7) RESET Command Parameter Sample...
-
Page 11: Troubleshooting
This equipment is equipped with a backup battery, but there is no switch to control the enabling of the backup battery. When the user gets the device, the backup battery is basically in the state of no power, and it needs to be connected to the external power for a short time to realize the power off alarm function. - Page 12 it.If you can connect to the device when calling,and hear a beep. Du, du. noise the SIM card is installed correctly and has deposited and please check with your operator for GPRS function. You also can check by searching the internet on your mobile phone. If you can not open website ,the GPRS function has not open .please contact with the operator to open ●...
-
Page 13: After Sales Service
10. After sales service 1.If products has technical changes ,we’ve no prior notice. 2.The shape and color, please in kind prevail 3.Warranty card applies to the specified IMEI number in the following table 4.Please properly keep this card and receipt in case of after-sales service 5.The following is for the warranty reference TELEPHONE... - Page 14 Maintenance Record Maintenance Card Maintenance DATE unit Fault statement Maintenance condition IMEI serviceman...
Need help?
Do you have a question about the T1-2 and is the answer not in the manual?
Questions and answers