Table 39 Tightening Torque (72011) - ABB HT568964 Operation Manual

Operation Manual / 4 Product description / A100-M axial
8 Disassembly and assembly
Fitting the wall insert
Figure 52: Fitting the wall insert
Part number
72011
Table 39: Tightening torque (72011)
1. Remove lifting device (90190/90195).
2. Slide wall insert (77000) into compressor casing up to stop and remove guide stud
(90319).
3. Secure wall insert with screws (72011) and washers (72008).
For assembly of the alternative air inlet, see section Removing / Installing air-inlets [➙ 60].
© Copyright 2016 ABB. All rights reserved.
A170-M
M20
580 Nm
HZTL4033_EN
Page 83 / 113
A175-M
M24
1000 Nm
Revision A July 2016