Sandleford KSS02 Instructions

WALL - MOUNT
KEY SAFE
Instructions
HOW TO OPEN/CLOSE THE KEY SAFE:
1. Open shutter to reveal dials.
2. Rotate dials to current set combination
(the Factory combination is preset to 0-0-0-0)
3. Push button 1 next to the dials to open.
4. After closing the front cover panel, jumble the dials to
protect your combination and lock the Key Safe.
5. Close the shutter.
HOW TO SET YOUR COMBINATION:
1. Open the key box, leave all dials at the current combination
(the Factory combination is preset to 0-0-0-0)
2. Push the RESET button from position A to position B,
as shown in Fig 1.
3. Rotate the number dials to the desired combination,
as seen in Fig 2.
4. Push the RESET button back to position A, the new
combination is now set.
5. Close the shutter board.
Fig 1.
HOW TO MOUNT YOUR KEY SAFE:
1. Open the Key Safe using the instructions above. Inside the
safe, there will be 5 holes on the backplate of the Safe.
2. Hold Key Safe in position on the wall and mark out the
holes with a pencil or marker.
3. Using a drill, drill four 6mm holes in the marked locations.
4. Place provided wall expander plugs into the drilled holes.
5. Move the Key Safe into position and secure using the
provided screws.
Button 1
Fig 2.
KSS02
Dials
Shutter
1
PAGE OF
2