1. General Information 1.1 Information about the instruction manual 1.2 Key to symbols 1.3 Liability and Warrantees 1.4 Copyright protection 1.5 Declaration of conformity 2. Safety 2.1 General information 2.2 Safety instructions for the commercial use of the device 2.3 Intended use 3.
1. General information 1.1 Information about the instruction manual This instruction manual contains information about the installation, operation and maintenance of the device, and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device.
device has been modified in line with new technology. If you have any questions, you should contact the manufacturer. NOTE! Read the instruction manual carefully before using the device. The manufacturer does not accept liability for any damage or malfunction resulting from not following the instructions for use.
To prevent hazards and to ensure optimum efficiency, no modifications or alterations to the device that are not explicitly approved by the manufacturer may be undertaken. This device may only be operated in technically proper and safe condition. 2.2 Safety instructions for commercial use of the device The specifications regarding industrial safety are based on the Regulations of the European Union applicable at the time of manufacturing the device.
In case of visible damage, do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery and notify us of any recorded damage. Hidden damages should be reclaimed immediately after detection, as claims for damages can only be asserted within the effective period for complaints.
4.2 Overview of parts Pressing-handle of the dasher Dasher, round filler Round Filler Oval filler Protection for cutting START-/STOP- discs button Safety lock Outlet Adjustment feet STOP button red START button green Safety devices The device is provided with 2 safety devices (micro switches): Safety lock with micro switch, that stops the device, as soon as the safety lid is opened for the cutting discs.
5. Installation and operation 5.1 Safety instructions WARNING! Electrical hazard! Connect the device to a properly installed and grounded single power socket. Never yank cord to disconnect from outlet. Cable must not touch any hot parts. • See that the cable does not touch any heat sources or sharp edges. Do not let the cable dangle over the counter edge.
• Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc.). • You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/electric heaters or other heat sources. • Make sure, that the device is grounded.
Page 10
• Insé rer d’abord le disque d’éjection en plastique. La mettre en accord avec les deux tourillons sur la plaque de l’arbre tournant. • Ensuite insé rer, selon besoin, l’une des disques de coupe rotatifs. Le disque de coupe rotatif doit ê tre insé...
6. Cleaning and care 6.1 Safety advice Before beginning with repair or cleaning works make sure the device has been disconnected from the power socket (pull the power plug!!!) and has cooled down. Do not use any acid agents and make sure no water ingresses the device. To protect yourself from electric shock, never immerse the device, its cables and the plug in water or other liquids.
Need help?
Do you have a question about the GSH and is the answer not in the manual?
Questions and answers