Sno-Way SWS 30 Installation & Owner's Manual

Advertisement

Quick Links

INSTALLATION &
OWNERS MANUAL
SWS 30
ON/OFF CONTROL
99101253
®
©2016 Sno-Way
International
97101997A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SWS 30 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sno-Way SWS 30

  • Page 1 INSTALLATION & OWNERS MANUAL SWS 30 ON/OFF CONTROL 99101253 ® ©2016 Sno-Way International 97101997A...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Page INTRODUCTION ......................2 SAFETY ........................3 INSTALLATION ......................4 Introduction ....................... 4 Tool List ......................4 Installation......................4 OPERATION........................ 6 Theory of Operation ..................6 On/Off Motor Controller Operation..............6 Wiring Harnesses ..................... 6...
  • Page 3: Introduction

    PHONE ( )– (FILL IN) CAUTION Sno-Way Service Parts Manuals are available on-line or at your authorized Sno-Way dealer. Request part number 97101915 for the SWS 30 Controllers. Factory contact information is available at Information, that if not carefully followed, can www.snoway.com.
  • Page 4: Safety

    The unit, or any part of it should not be decals are in place and are legible before operation altered without prior written approval of the manufacturer. begins. New decals can be obtained from Sno-Way or your local dealer. ALWAYS...
  • Page 5: Installation

    • Toggle Switch wire harness. REMEMBER After the SWS 30 is installed on the • Female Terminal (2) vehicle, the Pre-Delivery Check List and Delivery • 3/8" Ring Terminal Check List must be completed.
  • Page 6 NOTE: If the hole has to be drilled through carpeting or insulation, reverse the direction of the drill until the carpet 16. Plug the SWS 30 to the installed harness. Determine has been penetrated, remove the carpet from the hole,...
  • Page 7: Operation

    OPERATION Theory of Operation Start: When the ON side of the switch is selected, current will be The ON/OFF switch only has one speed. Turn the switch directed to the SWS pump motor. When the OFF side of ON and the pump motor turns on full spraying speed. Turn the switch is selected, current to the system end.
  • Page 8 ® SNO-WAY INTERNATIONAL, INC. Hartford, WI 53027 USA Website: www.snoway.com © ® 2016 Sno-Way International...

Table of Contents