Advertisement
• Select Cleverboard 3 driver and click on "Go". The driver
installation will now take place but will not yet be complete.
• Once the (part) driver installation has completed attach the
Cleverboard 3 to the computer with the USB cable.
• The computer will recognize that a new USB device has been
plugged in and prompt you to complete the driver installation
from the disk that is already in your CD tray.
• Follow your on screen instructions and finish the driver
installation.
• Now install the Lynx software (from the same disk) and when
prompted to do so add the "Lynx Serial Number" and the
"Wordwall License Key" numbers which you will find on the
back of the CD case.
• Once driver and Lynx software has been successfully loaded re-
start your computer to ensure that all changes have taken place.
Essential Connections:
• Ensure Cleverboard 3 is mounted on the wall or on a floor stand.
• Connect computer to Cleverboard 3 with the USB cable provided.
• Connect computer to projector with VGA cable.
• Ensure all connections are made and then turn on computer and
projector.
• Adjust projected image size to fit your board and focus the image.
Beginning an Interactive session:
Ensure that all connections have been made as per the section above.
Ensure that the "Left Hand Door" is in the open position on the
Cleverboard 3.
Ensure that the Interactive pen has a fresh battery in it and makes a
"buzzing" sound when the tip is depressed and the unit held closely to
the ear,
Advertisement
