2. Select a path No. from the drop-down list, and click the icon
patrol path.
3. Click
to add a preset into the path, and click
4. Set the preset number, speed and lingering time at each preset. You can adjust the
order of presets by using
5. Click OK to save patrol path.
Note:
Up to 32 patrol paths can be set, and each path supporting 16 key points at
most.
Calling a Patrol
Steps:
1. Click to select a PTZ View on the display window.
2. Select the patrol path number from the drop-down list.
3. Click the icon
Deleting a Patrol
1. Select the patrol path number from the drop-down list.
2. Click the icon
User Manual of Network Fisheye Camera
Patrol Configuration (1)
Figure 4-8
and
.
Patrol Configuration (2)
Figure 4-9
to start the selected patrol and
to delete the patrol path.
27
to configure
to delete a preset.
to stop it.