Optional Accessories; Troubleshooting - Vax Swift V-055 Easy Manual

Optional accessories

TM
TurboTool
How to use
TM
• The TurboTool fits on the end of the telescopic tubes and/or hose grip.
• Perfect for cleaning stairs and upholstery.
TM
• The TurboTool should be pulled backwards for optimum cleaning.
Clearing blockages
• Rotate the locking ring 180˚, then turn the TurboTool
• Pivot the lower housing open, then remove any obstructions.
• To re-assemble, ensure the tabs are engaged, pivot the lower housing closed
then re-position the locking ring.

Troubleshooting

Problem
Cleaner won't run
Cleaner won't pick up/loss of suction
Dust escaping from cleaner
Turbobrush
Please note
• The Turbobrush is especially suited for looking after rugs and carpets. The
Turbobrush is not suitable for hand-knotted or extremely deep pile rugs and
carpets. There is a danger that threads will be pulled.
Clearing blockages
• In case of a defective drivebelt, call the Vax Careline 0870 6061248.
• Disconnect the vacuum cleaner from the power supply before cleaning the
brushes.
• Cut the threads and hairs from around the brushbar.
• The debris can be vacuumed up afterwards.
TM
over.
Possible cause
• Power cord not firmly pushed into mains socket.
• Blown fuse or tripped circuit breaker.
• Dust container not installed properly.
• Dust container full.
• Nozzle/dirt passage clogged.
• Filters are clogged.
• Dust container not installed properly.
• Dust container is full.
Possible solution
• Plug cord in firmly to power outlet.
• Check fuse/breaker. Replace fuse or reset breaker.
• Re-install dust container.
• See 'How to empty the dust container' (fig.13-16a).
• Remove obstruction.
• Clean or replace filters (fig.17-20).
• Re-install dust container.
• See 'How to empty the dust container' (fig.13-16a).