Hisense HRT180N6AWE Use & Care Manual page 13

For hygienic reasons the appliance (including
exterior and interior accessories) should be
cleaned at least every two months.
A CAUTION
The appliance must not be connected to the
wall outlet during cleaning. Danger of
electrical shock! Before cleaning, switch the
off
appliance and remove the plug from the
wall outlet socket.
Exterior Cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Spray water onto a cleaning cloth instead
of spraying directly on the surface of the
appliance. This helps ensure an even distribu­
tion of moisture to the surface.
Clean the doors, handles and cabinet
surfaces with a mild detergent and then wipe
dry with a soft cloth.
A CAUTION
Don't use sharp objects to clean as
they are likely to scratch the surface.
Don't use thinner, Car
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning. They
may damage the surface of the appliance
and may cause fire.
Interior Cleaning
You should clean the appliance interior
regularly. It will be easier to clean when food
stocks are low. Wipe the inside of the fridge
and freezer with a weak solution of baking
soda and water, and then rinse with warm
water using a wrung-out sponge or cloth.
Wipe completely dry before replacing the
shelves and baskets. Thoroughly dry all
surfaces and removable parts before
putting them back into place. Although
this appliance automatically defrosts.
13
detergent, bleach,
a layer of frost may occur on the freezer
compartments interior walls if the freezer door
is opened frequently or kept open too long. If
the frost is too thick, choose a time when the
freezer is nearly empty and proceed as
follows:
l . Remove existing food and accessory
baskets, unplug the appliance from the main
power and leave the doors open. Ventilate
the room thoroughly to accelerate the
process.
2. When defrosting is completed, clean your
freezer as described above.
A wARNING
Do not use sharp objects to remove frost from
the freezer compartment. Only after the
interior is completely dry should the appliance
be switched back on and plugged back into
the main socket.
Door Gasket Cleaning
Take care to keep the door gasket clean.
Sticky food and drinks can cause the
gasket to stick to the cabinet and tear
when you open the door. Wash gasket with
a mild detergent and warm water. Rinse
and dry the gasket thoroughly after
cleaning.
A CAUTION
Only after the door seals are completely dry
should the appliance be powered on.
Replacing the LED Light
Warning: The LED light must be replaced by a
competent person. If the LED light is
damage d, follow the steps below:
l. Unplug your appliance.
2. Remove the light cover by lifting up and
puling out the LED light.
3. Hold the LED light with one hand and pull it
with the other hand while pressing the
connector latch.
4. Replace the LED light and snap it
correctly in place and reattach the light
cover.