Jeulin 482 072 Quick Start Manual page 6

ExAO
UV sensor
Ref : 482 072
2.2 Inserting the sensor
The sensor is connected using the connector on the back of the case:
2.3 Operation in standalone mode
Start up
Insert the sensor in the measurement channel
Switch on the console or the pod
Display
A value is displayed directly on the sensor. The change from one function to the other or
from one sensor to the other is made as described above
Reset
The detection system can be reset.
Close off the light sensitive sensor
Make a long press on the red button (3) until a flashing arrow appears at the bottom left of
the display
Make a long press to validate the reset
2.4 Connected to the PC
2.4.1 Foxy
Start up
Connect the sensor to the console
Switch the console on
- connect the console to the computer
- once the software is running, choose an application
Parameter settings
Slide the sensor icon on one of the axes
The settings are available in the tabs under the axes.
2.4.2 AirNeXT
Start up
Insert the sensor in the pod
Connect AirNeXT
Switch AirNeXT
Once the software is running, choose an application
Wait until the pod is detected and then validate
Parameter settings
Slide the sensor icon on one of the axes
The settings are available in the tabs under the axes.
Note : In this operating mode, the sensor buttons are deactivated and the settings are made
through the software.
ENGLISH
- align the sensor with the measurement channel (pod or console).
- insert the sensor into the guide system.
- follow the console guide system.
- push in all the way.
® ®
and Tooxy
®
®
to the computer
®
and the pod on
5