Siemens LC66HA541T Instruction Manual page 9

Removing metal grease filter
Open the lock on the underside of the appliance and remove
1.
the metal grease filters from the retainer.
Note: Grease may accumulate in the bottom of the metal
grease filter. Hold the metal grease filter level, otherwise
grease will drip out.
Clean the metal grease filter.
2.
After removing the filters, clean the inside of the appliance.
3.
Clean the filter cover.
4.
Installing the metal mesh grease filter
Insert the metal grease filters with the lock to the front.
1.
Insert the metal grease filters on the underside of the
appliance.
Fold the metal grease filters inwards, locking them in place.
2.
Press and hold the button for more than three seconds.
#
3.
The saturation indicator is reset.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
The activated charcoal filters are not included in the delivery.
■
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Removing the activated charcoal filter
To remove the metal grease filter, see above.
1.
Undo the screw connections on the retainer.
2.
Fold the retainer down and remove it.
3.
Fitting the activated charcoal filter
Slide the new activated charcoal filter into the retainer.
1.
Slide the wire into the retainer.
2.
Insert the retainer into the extractor hood.
3.
Close the screw connections on the retainer.
4.
To fit the metal grease filter, see above.
5.
Press and hold the button until the saturation indicator no
#
6.
longer flashes.
The saturation indicator is reset.
¨
©
9