Advertisement
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Use extreme caution when drilling holes to avoid damaging fuel lines, hydraulic lines or
existing wiring.
• If additional wiring is required, we recommend that you run all wires prior to mounting
your speaker in place.
• Use the highest quality connectors for a reliable installation and to minimize signal and
power loss.
• Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel lines,
hydraulic lines, vacuum lines or electrical wiring.
• Avoid running wires over, near, or through sharp edged surfaces. We suggest you also
use rubber grommets to protect any wires routed through metal.
Mounting and Installation
• Determine where the speakers will be mounted. Ensure an area large enough for the
speaker to mount evenly. Be sure the mounting location is deep enough for the speaker
to fit.
• Using an appropriate tool, cut a 4 3/8" diameter mounting hole (Model 18006619) or 5
1/4" diameter mounting hole (Model 18006627).
• Use the speaker as a template to mark the locations for the mounting screws. Drill
the mounting screw holes with a 1/8" pilot bit. Route speaker wires and connect to
speakers, observing speaker polarity.
• Install speaker into opening using supplied hardware and test for correct operation.
Preparation/Installation
westmarine.com
2
1-800- 262-8464
Advertisement
