Rear Panel Connections - azur 851N Manual

8

Rear Panel Connections

Last updated: 八月 9, 2022 02:50. Revision #5675
1. Power On/Off
Switches the 851N on and off.
2. Mains Voltage Selector Switch (CU Version)
Switches the mains voltage between 100V and 115V.
Note: For use by Cambridge Audio service personnel only.
3. AC Power Socket
Once you have completed all connections to the amplifier, plug the AC power cable into an appropriate mains socket then switch on.
4. USB Sockets
Pre-fitted Wi-Fi dongle and connection for USB HD/flash disk or optional BT100 Bluetooth audio receiver.
The USB ports are not intended for connection to Apple mobile devices, no functionality, charging or otherwise, is supported.
The Wi-Fi dongle is pre-fitted. Your unit will default to an Ethernet connection if one is made, however it is advised to remove the Wi-Fi dongle if using an
Ethernet connection.
If you are using this 851N with Wi-Fi please make sure your unit is positioned within range of your wireless router.
Important Note: Do not connect/disconnect the Wi-Fi dongle when the unit is on.
5. Ethernet
Use to connect the 851N directly to a router.
6. Digital Inputs (D1, D2, D3 and D4)
TOSLINK Optical and S/P DIF coaxial digital inputs.
Coaxial – Use a high quality 75 ohm digital RCA Phono interconnect cable (This is different from an analogue audio phono interconnect). This input is
suitable for 16-24 bit content up to 192kHz.
TOSLINK Optical – Use a high quality TOSLINK fibre optic interconnect cable designed specifically for audio use. This input is suitable for 16-24 bit content