Page 2
Introduction Do you have a our Battery-Powered Motion-Activated Dual Head LED Security Spotlight (model 43218)? Do you want to adjust the light heads so they are tighter or looser? Luckily, they can be adjusted quickly with a paperclip and a Phillips-head screw driver.
Page 3
Step 1: Locate Rubber Screw Cover Lay the product on its side with the loose head on top as shown in the picture. Located the screw head cover, shown here in the red circle. This is a small rubber cover that prevents moisture from getting to the top of the screw and causing rust.
Page 4
Step 2: Remove Rubber Cover Unfold a paperclip and use the end to poke the edge of the rubber cover. Carefully slide the end of the paperclip past the rubber cover. Then, press the paperclip against the rubber cover and pull the paperclip out.
Page 5
Check the head to see how it rotates and continue to loosen until you reach the desired point. Rely on premium home lighting by MAXSA if you’re looking for quality and efficiency.
Need help?
Do you have a question about the 43218 and is the answer not in the manual?
Questions and answers