Advertisement
Connecting the Computer Module
If you haven't already done so, read the information about configuration
software on page 3 BEFORE you connect any modules.
1. Plug the power source into a power outlet. Then plug the power source into
the computer module.
2. Attach one end of the parallel cable (included with your Bidirectional Wireless
Print Sharer) to the computer module and the other end to your computer's
LPT1 port.
3. The green light on the computer module should turn on and stay on. This
means it's ready to transmit data. When it's transmitting data, the green light
will blink rapidly.
4. Repeat these steps for each additional computer module.
Installation is now complete, and you're ready to print wirelessly!
IMPORTANT
QUICK INSTALLATION GUIDE
5
Advertisement
