Samsung NX60 8 Series Installation Manual page 52

Installation instructions
To check and adjust the oven burner air adjustment shutters:
1. Open the oven door.
2. Remove the oven racks.
3. Remove the oven floor.
4. Press the Bake pad, then the START/SET pad.
5. After the oven has lit, visually check the flames coming out of the upper and
lower burners. If adjustment is needed, carefully adjust the air adjustment
shutters.
Locking screw
NOTE
If the range is set up for LP gas, small yellow tips at the end of the cones are
normal.
Locking screw
24 English
Install_NX60T8755SS_AP_DG68-01326A-01_MES+EN.indb 24 Install_NX60T8755SS_AP_DG68-01326A-01_MES+EN.indb 24
The shutters are located at the base of the
burner manifolds near the back oven wall.
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If flames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
flames are stabilized.
If flames are too yellow and/or too large,
gradually increase the air shutter opening
until the flames have approximately a 1-in
blue cone.
After the flames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
To adjust flame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set
Screw
Small
Screwdriver
Valve Stem
WARNING
1. Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2. After adjusting the valve set screw, inspect the assembly for gas leaks.
1. Rotate a knob to LO position and remove
the knob from the valve stem while the
flame is lit.
2. Carefully push the screw driver into the
stem of the valve, until it hits the simmer
set screw. Make sure the screwdriver
flathead is seated into the set screw
groove.
3. Rotate valve set screw clockwise to
decrease LO setting flame output, or
rotate set screw counter clockwise to
increase LO setting flame output.
2021-02-19 오후 6:49:32 2021-02-19 오후 6:49:32