Table of Contents
Advertisement
TV System (Default: PAL)
Set the TV system.
Video
Still Mode
TV System
Video Out
PAL:
Outputs a modified PAL signal for viewing discs recorded
with the NTSC system on a PAL system TV.
Auto:
Changes the video system (PAL / NTSC) automatically
according to the format of the inserted disc.
Video Out (Default: SCART(RGB))
Sets the video output signal to be fixed accordingly to your TV set.
Video
Still Mode
TV System
Video Out
Refer to page 15 for more details.
If you select "SCART (RGB)" or "Component Interlace (I)", proceed to step 5.
SCART(RGB):
Select "SCART(RGB)" if your TV has a scart terminal and
connected to it.
Component Progressive (P):
If your TV is compatible with progressive scanning, select
"Component Progressive (P)" and make sure the connection
indicated by each jacks (Y / P
Video - Video Out
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.
NOTE: If there is no picture or picture is
distorted after selecting "Yes",
Wait about 15 seconds for auto recovery.
Activate?
Select "Yes" using [Cursor
s / B], then press [ENTER].
Component Interlace (I):
If your TV that have component jacks, select "Component
Interlace (I)" and make sure the connection indicated by each
jacks (Y / C
5
Press [SETUP] to exit.
86
EN
Downloaded from:
http://www.usersmanualguide.com/
Changing the Setup menu
Video setting (cont'd)
DVD
Auto
PAL
SCART(RGB)
DVD
Auto
PAL
SCART(RGB)
/ P
) properly.
B
R
DVD
Yes
No
/ C
) properly.
B
R
Video - TV System
PAL
Auto
Video - Video Out
SCART(RGB)
Component Progressive (P)
Component Interlace (I)
Video - Video Out
DVD
Confirm again to use progressive scan.
If Picture is good, Select "Yes".
Yes
No
Select "Yes" using [Cursor
K / L], then press [ENTER]
within 15 seconds.
Select the desired system set-
DVD
ting using [Cursor K / L], then
press [ENTER].
Note
• With discs recorded using the
PAL system, a PAL signal is
output for viewing on a PAL
system TV.
• Discs recorded with the PAL
system cannot be viewed on
an NTSC system TV.
• With discs recorded using the
NTSC system, an NTSC signal
is output for viewing on an
NTSC or Multi system TV.
• With discs recorded using the
NTSC system, select PAL to
view on a PAL system TV.
Select the desired setting
DVD
using [Cursor K / L], then press
[ENTER].
Note
• When changing the Video
Out setting (SCART(RGB),
Component Interlace (I) or
Component Progressive (P)),
connect to a VIDEO jack or
an S-VIDEO jack on the TV.
If the setting is changed, for
example, to SCART(RGB) while
the COMPONENT VIDEO OUT
jacks are used to connect
to the TV, a distorted video
signal may be output.
• When "Component
Progressive (P)" is selected,
"P.SCAN" will appear on the
front panel display.
OPERATE
DUBBING
TIMER PROG.
T-SET
SHOW VIEW
VCR
ZOOM
OPEN/CLOSE
SETUP
EJECT
5
REC MODE
RAPID PLAY
DVD
CM SKIP
Advertisement
Table of Contents
