Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATION MANUAL
MODELS
RS-500
RS-750
Rev E
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes to the pur-
chaser upon receipt from the carrier. Consequently, claims
for the material damaged in shipment must be made by
the purchaser against the transportation company at the
time shipment is received.
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
BE SAFE
Ranger™ spray wash cabinets are designed and built with
safety in mind. However, proper training and thoughtful
operation on the part of the operator can increase your
overall safety. DO NOT operate or repair this equipment
without reading this manual and the important safety
instructions shown inside.
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual .
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free: 1-800-253-2363
www.rangerproducts.com
REV G 07/11/2013
P/N 5900121
Tel: 1-805-933-9970
Fax: 1-805-933-9160
Advertisement
Table of Contents
Related Manuals for Ranger Products RS-500
Summary of Contents for Ranger Products RS-500
- Page 1 OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH. REV G 07/11/2013 P/N 5900121 INSTALLATION AND OPERATION MANUAL MODELS RS-500 RS-750 Rev E Keep this operation manual near the machine at all times. Make sure that ALL USERS read this manual .
-
Page 2: Warranty Policy
Defective parts replaced at no charge must be returned • Freight damaged items. If your shipment arrives to your dealer or Ranger Products™ within 60 days of damaged you must note the damage on the car- the date that the replacement parts are shipped; other- rier’s delivery record in accordance with the carrier’s... -
Page 3: How To Return Products
BendPak customer service representative will work with you to arrange to have the item(s) returned via a BendPak preferred carrier freight collect. Ranger Products Products returned C.O.D. will be refused. Unauthorized 1645 Lemonwood Dr. freight collect charges will be denied. -
Page 4: Environmental Issues
ENVIRONMENTAL ISSUES Read this entire manual before attempting to install your Protect your environment and protect your business from Ranger Products™ parts washer. fines by handling your dirt cleaning solution according to federal, state, and local codes. According to federal... -
Page 5: Controls Operation
CONTROLS / OPERATION INSTALLATION Your parts washer is designed to clean parts (removing contaminants such as oil, grease, dirt, etc…) with a recirculated detergent and water solution. The washer DANGER! cleans with a combination of mechanical force, heat (160-180F), and the chemical action of the detergent. This machine utilizes high voltage. -
Page 6: Start-Up Procedure
1-2 hours necessary to heat the water, add detergent, and run the wash cycle Ranger Products does not warranty their product against for at least 1 hour. Otherwise, rust may occur. rust. Rust will occur if the wrong detergent is used, if the start-up procedure is not followed, or if the machine is not ♦... - Page 7 The more wash time you run, the more the cabinet gets coated with rust inhibitors. IF YOU ENCOUNTERED ANY PROBLEMS DURING START-UP, CALL YOUR RANGER PRODUCTS™ DEALER...
-
Page 8: Maintenance
MAINTENANCE REMOVING SLUDGE FROM THE TANK Assign the responsibility for your parts washer to one person to avoid abuse and neglect. Daily: ♦ Check the water level, which should be inside the filter basket. Never allow the water level to get below the filter basket. -
Page 9: Troubleshooting Guide
TROUBLE SHOOTING GUIDE SYMPTOM PROBLEM / REMEDY Nothing works-heat or pump • Breaker is off, no power to machine Check all control fuses Cleaning is poor • Wrong detergent, low detergent concentration or hard water • Clogged nozzles • Solution is too dirty •... - Page 19 Phone: Total Price: Fax: Email: Submitting an Order: (via mail, fax, or phone) Mail: Ranger Products, 1645 Lemonwood Dr., Santa Paula, CA 93060 Call: 1-805-933-9970 Fax: 1-805-933-9160 Please allow 10 -14 days for shipment Method of Payment: (circle one) Check enclosed...
- Page 22 For Parts Or Service Contact: BendPak Inc. / Ranger Products 1645 Lemonwood Dr. Santa Paula, CA. 93060 Tel: 1-805-933-9970 Toll Free: 1-800-253-2363 Fax: 1-805-933-9160 www.rangerproducts.com...
Need help?
Do you have a question about the RS-500 and is the answer not in the manual?
Questions and answers