Panasonic CS-E9DKDW Service Manual page 45

Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
I ndoor Unit I ndoor Unit
Front panel
Air filter
Airflow direction louver
Discharged air
Do not touch
during operation
Outdoor Unit Outdoor Unit
Air inlet
(rear)
Air inlet
(side)
Remote Control Remote Control
LCD display
Ion operation
Operation mode
Airflow direction
adjustment
Memory reset
Check
Troubleshooting
G Operation delayed for few minutes after restart.
G Sound like water fl owing during operation.
G Mist emerges from indoor unit.
G Noisy during operations.
G Remote control/display does not work.
G The unit cannot operate.
G Outdoor unit emits water/steam.
Air intake
Supersonic air
purifying device
Auto OFF/ON
button
Receiver
Ionizer
Indicator
POWER TIMER QUIET POWERFUL ION
Air outlet
Transmitter
Temperature setting
Off/On
Quiet operation
Powerful operation
Fan speed selection
Timer setting
Clock setting
➤
This is a normal self protection control.
➤
Caused by refrigerant fl ow inside.
➤
Condensation effect due to cooling process.
➤
Installation work could be slanted or front panel didn't close properly.
➤
Check whether batteries are correctly inserted or need replacement.
➤
Check either circuit breaker is tripped or timer is used correctly.
➤
Condensation or evaporation happens at piping surface.
45
CS-E9DKDW CU-E9DKD / CS-E12DKDW CU-E12DKD
I About
Remote Control Preparation
1. Pull out
3. Press CLOCK button
5. Press again to confi rm
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
SUPER
ALLERU-BUSTER
• The batteries must be
recycled or disposed of
properly.
Remote Control Signal
• Make sure it is not obstructed.
• Maximum distances: 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Auto OFF/ON Button
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Action
Press once
Press until "beep"
sound and release.
Press until "beep"
sound and release.
Press again until
"beep-beep" sound
and release.
• To OFF, press again the Auto OFF/
ON button.
2. Insert
batteries
(AAA or
R03)
4. Set
current
time
Operation
mode
Automatic
Operation
Cooling
Operation
Heating
Operation