Table of Contents
Advertisement
If provided
© Copyright 2015 ABB. All rights reserved.
Disassembly and assembly
Disassembling and assembling
turbocharger
Plug in the cable connector (86515) for the speed sensor (86505) and
(if provided) fit the insulation plates (1, 2).
Removing gas outlet bend and gas outlet flange
Disconnect all lines in accordance with engine builder's instructions
and remove insulation. (See also preceding chapter.)
Loop lifting gear around gas outlet bend (51100).
Remove gas outlet bend (51100) and gasket (52406). Only gas outlet
bends from ABB Turbo Systems have the gasket (52406).
Remove gas outlet flange (52400) and, if fitted, C-ring (52408).
Operation Manual / TPS44-F.. - TPS61-F..
8
8.3
Page 105
Advertisement
Table of Contents
