Table of Contents
Advertisement
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Installing cartridge group
Attach lifting gear to lifting device (90190) and turn compressor casing
(72000).
By hand, screw three press-off nuts (61090) onto bearing casing
studs, equally spaced around circumference and up to end of thread.
Push compressor casing (72000) onto cartridge group to fit snugly and
fasten it using nuts (61037).
Secure three press-off nuts (61090) against compressor casing
(72000) by tightening them to specified torque. (See chapter Table of
tightening torques.)
Remove lifting device (90190).
Fit sealing air line (56501) between compressor casing (72000) and
variable turbine geometry module (56100).
Operation Manual / TPL65VA32/33
8
8.9
Page 102
Advertisement
Table of Contents
