Matrix Switch Corporation MSC-5-3232 Product Manual page 51

X
X DEST
X DEST, SRC
X DEST, SRC, LEVEL
When querying connection state, sources for each level are separated by commas (multi-level systems only) and
are displayed for each destination and separated by newlines.
The value 0 can be used for DEST to switch all destinations to a given source. A level may also be specified to
isolate switching a single level of all destinations. (Protocol Version 2.2)
The value 0 can be used for SRC to Mute a destination (if supported for a given level).
Examples
>X
1,1
2,2
3,8
0,4
>X 3
3,8
>X 3,4
>X 4,0,2
>
In the above examples the first command queries the matrix routing state (typical of a 16x4 system for
example), the second command queries destination 3 only, the third command connects source 4 to destination 3
on all levels and the fourth command mutes destination 4 level 2.
Command stacking
Command stacking is especially useful for the X command, since it allows for several connections to be
performed at the same time.
Example
>X1,4#X2,3#X3,2#X4,1
>
The above would connect source 4 to destination 1, source 3 to destination 2, source 2 to destination 3 and
source 1 to destination 4 for all levels.
Page 51 of 61
MSC-5-3232 Product Manual
Query complete routing state (equivalent to S Command).
Query connected sources for DEST for all levels.
Connect SRC to DEST for all levels.
Connect SRC to DEST/LEVEL.
© 2013-2016 Matrix Switch Corporation www.matrixswitch corp.com