Nobile 9109011004 Mounting And Operation Instructions page 2

Mounting-/
Operation Instruction
EN
Safe use of the product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these
instructions the warranty expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance
with existing standards and local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation,
make sure any component of the entire installation does not bear a risk of life. According to common practice, please perform a standard function
test, before installing. To make maintenance work possible, the lighting system should be accessible after installation (auditable).
Technical Specification
Transmission protocol
Operation Frequency
Transmission Power
BLE Range
Detecting Range
Viewing angel
Brightness detection range
Battery
Ambient Temperature Ta
Mounting:
Open the backside of the device. Then remove the insulation sheet on the battery. Add the device in you Smartmatic 2.0 App before installation.
For good detection range, the installation height should be 1.8m ~ 2.1m.
Commissioning
To add the device in your nobile Smartmatic 2.0 App, select "Add Device". Press the button for 5 seconds until the LED starts blinking. The device
icon will appear in the nobile Smartmatic 2.0 App screen. Then select "Add", this will take from 10 seconds to 2 minutes depending on the signal
strength. Select "Next", you will see a "Added successfully" notification signifying that the device is now added in the app. Then lastly select "Done"
Controlling the Device:
The Smartmatic 2.0 App will show the value of the detected brightness and will create a record every time the device detects a presence.
PIR Motion and brightness sensor BT
BLE 4.2
2.40 GHz
10 dBm
up to 90 meters in free field
max. 8m
120°
0 ~ 1000 lux
CR123A (3V)
-10 ~ 50°C
Blinking
LED
OFF
Reset or enter
Button configuration
mode
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
For more specifications, please
refer to the data sheet of this
product.
The device enters BLE network configuration mode(preparing to
connect the gateway)
The device is under standby status
Press and hold the button for 5 seconds until the blue LED blinks, the
device will enter configuration mode
rev. 0.0 – 08.04.2022
free to download
nobile Smartmatic 2.0 APP
on Google Play or Apple APP Store