Table of Contents
Advertisement
4.4 Installation Steps
4.4. 1 Drill the Flue Hole
Ensure that there are no gas or water lines, or electrical circuits in the wall location where the flue
hole is to be drilled.
Drill the flue hole using a Ø3 1/8 in. (Ø80 mm) drill. A template is provided on the furnace carton
box. The center of the hole must be located anywhere within the shaded area, unless extension kits
are used. See the dimensions diagram.
For weatherboard walls, drill through the center of the weatherboard from the outside first and then
through the plasterboard.
Flue Hole
Figure 8
4.4.2 Attach Wall Brackets
Attach the wall brackets as shown. A template is provided.
Figure 10
16
Example template located on furnace carton box
Figure 9
1 3/16 in. (30 mm)
Wall Bracket
EX38DT Installation and Operation Manual
28 7/16 in. (723 mm)
15/16 in. (24 mm)
Advertisement
Table of Contents
