14POINT7 SLC DIY 2 Assembly Manual page 7

P a g e | 7
Mounting PCB into the Case
JP5
Mount the Display unit, Display panel, and SLC DIY 2 PCB into the case and secure using screws.
Check to make sure the
The distance from the hole in the display panel to the top
metal screws are not touching any component on the PCB.
and bottom edge is not perfectly symmetric, try installing the panel both ways and see which gives you the best fit. You
may need to tighten or loosen the screws to get the perfect fit between the button and the hole in the faceplate.
Install the jumpers on JP5 as in the above picture. The jumpers do not matter at this point, but just install them now so
you do not lose them. The Jumpers select between accelerometer and analog 0-5[v] input for datalogging, see section
1.6 of the SLC DIY 2 User Manual for more information.
Finally, secure the top of the enclosure to the bottom using the supplied screws.
There is no backplate for SLC DIY 2.