Other Features; Specifications - Platinum Tools TDG310 User Manual

OPERATING INSTRUCTIONS
PD (Powered Device) Emulation
Connect a patch cable from the PoE switch or PSE power supply device
to the "PD" port of the probe. If the indicator light is on, it means the port
has been configured for PoE output and voltage is detected. There are 4
indicator lights on the "PD" port. When testing the pins used for power, if
the 1, 2, 3 and 6 indicators are lit, the PoE port is supplying power through
pairs 1/2 and 3/6. If the 4, 5, 7, and 8 indicators are lit, the PoE port is
supplying power through pairs 4/5 and 7/8. If all indicators are lit, the PoE
port is supplying through all four pairs 1/2, 3/6, 4/5 and 7/8.
This function is useful for checking the pins a PoE switch or other source
is using to supply power, to avoid causing damage to a camera or other
device.

Other Features

Line DC Level and Positive/Negative Polarity Testing
Using the BNC-to-Alligator clips cable, turn off the tone generator and clip
the red and black wire clips to the telephone line or battery. Then, connect
the cable to the BNC port of the tone generator. If the telephone cable is
terminated with an RJ11 connector, connect the telephone cable to the
RJ11 port instead.
If the indicator light is in green, that means the red wire clip is positive and
the black clip is negative. If the indicator light is in red, the black is positive
and the red is negative. The brightness of the indicator light also shows the
level, with a brighter light indicating a higher level.
16

SPECIFICATIONS

Item Digital Tone Generator and Probe Kit
Tone Generation Digital signal (rejects noise and false signals)
Cable types RJ45 Twisted pair, RJ11 telephone line, BNC cable, etc.
LED wire map, shielded cable and shielding continuity
indicator, check cable type indicator: straight/cross/other,
UTP cable test
2-pair/4-pair continuity test, triple zone short testing, UTP
cable short circuit test
Continuity test
Detect the continuity of the pins on both sides of network
of RJ45 cable
cable and short circuits
connectors
PoE switch power supplying status test and check the
PD (powered) test
pins used for power supply
LED lamp Short press On/Off LED light
Long press "Mute" button to switch silent mode, find
Silent mode
cable through LED strength indicators
Audio output Supports external audio output and mono earphone jack
Power Supply
External power
Four AA batteries
supply
General
Operating Voltage Up to 60VDC between pins
Working
-10c — +50c
Temperature
Working Humidity 30%-90%
Dimension and Weight
152mm x 62mm x 27mm (6.0" x 2.4" x 1.1")
Tone generator
0.12Kg (4.23 oz)
218mm x 48mm x 32mm (8.6" x 1.9" x 1.3")
Probe
0.1Kg (3.5 oz)
17