GmbH & Co. KG [hereafter referred to as orangedental] only considers itself responsible for the effects on safety, reliability and performance of the device, if:...
Page 4
opt – /opt – Instructions for Use | the proper and safe condition of the product. the storage of the instruction manual at the location of use. following the safety instructions contained in these instructions (see chapter 1.3: Conventions, Symbols Used). Page 2 of 15 Date: 11.10.2019 00.000.527-08 | EN...
opt – /opt – Instructions for Use | 1.2. Contents Dear Customer ....................1 1.1. Prologue ......................1 1.1.1. Responsibility of the Manufacturer ............1 1.1.2. Responsibility of the Operator ..............1 1.2. Contents ......................3 1.3. Conventions, Symbols Used ................4 About the Product ..................
opt – /opt – Instructions for Use | 1.3. Conventions, Symbols Used In these instructions, the conventions set out below indicate important information: This symbol is used if deviating from the procedure described ARNING can lead to physical injury or death. This symbol is used if deviating from the procedure described AUTION can lead to damage to the product or to loss of data.
Page 7
opt – /opt – Instructions for Use | CE M ARKING This symbol, attached by the manufacturer, indicates that the medical product is in conformity with and fulfills all requirements of the medical device directive 93/42/EWG. 00.000.527-08 | EN Date: 11.10.2019 Page 5 of 15...
00.001.934 micro fiber tissue zub0498210 zublup0499290 manual 00.000.527 2.3. Accessories/ Spare Parts All parts can be ordered at your dealer or orangedental. 2.3.1. Spare Parts Loupe Frame Frame No. frame right left No. frame temple temple...
opt – /opt – Instructions for Use | INDIVIDUAL FITTING opt – /opt – Your has been produced individually for your interpupillary and working distance. You can take the following additional fittings: 3.1. Fitting of Nose Pads There are two different nose pad positions: >>...
If your loupe needs to be repaired, you can send the loupe to your dealer or orangedental. Often it is possible just to order the spare parts and mount the parts on your own, to save time and money. You can also change the Varioclips to change the working distance.
opt – /opt – Instructions for Use | 4.2. Change the Hinge Remove the temple (see section 4.1: Change the Temple) Push a solid, pointed tool (e.g. little screw driver) against the small silver round area. Push the part outside Remove the broken hinge.
Slide until your hear CLICK and the Varioclip removes. Take the Varioclip away. Pose the new one at the bottom of the ocular. Slightly push the orangedental logo on the upper side of the clip until your hear CLICK. 00.000.527-08 | EN Date: 11.10.2019...
opt – /opt – Instructions for Use | SAFETY, SERVICING AND MAINTENANCE opt – /opt – Please read safety instruction MPORTANT Please read manual attentively. MPORTANT When wearing the loupes do not look directly at the sun or TTENTION any other bright light source to avoid injuries of your eyes. Do not leave the loupe where it is exposed to direct sunlight TTENTION as this could lead to a fire.
opt – /opt – Instructions for Use | Any sterilization (autoclave/chemical clave procedures, AUTION iodinated agents or other proceedings) is not possible. 5.2.1. Disinfection Agents for opt–on /opt–on opt – /opt – The best way to disinfect your is using a medically approved disinfection wipes, offering a broad spectrum of activity against bacteria, fungi and viruses e.g.
– /opt – Instructions for Use | SPECIFICATIONS AND CONFORMITY orangedental GmbH & Co. KG Aspachstrasse 11 | 88400 Biberach / Riss 6.1. Requirements regarding the Practice Environment opt – /opt – Important: The loupe is solely used to support the...
opt – /opt – Instructions for Use | Transport Temperature: -40°C to +60°C Rel. humidity: 10 to 90% Air pressure: 500 hPa to 1060 hPa 6.2.3. Conformity with Standards Classification according to 93/42/EEC 00.000.527-08 | EN Date: 11.10.2019 Page 15 of 15...