Page 1
USER’S MANUAL SI-700 - EIA-232/ EIA-485 INTERFACE JUL / 05 SI-700 VERSION 1 S I 7 0 0 M E FOUNDATION...
Page 2
Specifications and information are subject to change without notice. Up-to-date address information is available on our website. web: www.smar.com/contactus.asp...
Page 3
SI-700 –EIA-232/EIA-485 Interface SI-700 – EIA-232/EIA-485 INTERFACE Part Number SI-700 (EIA-232/EIA-485 Interface) Description This module converts the electrical characteristics of the communication signal from the EIA-232 specification to the EIA-485 specification. Due to the fundamental differences between the EIA-232 and the EIA-485, the first option EIA-232 is used in peer-to-peer applications) this module was implemented to work automatically.
SI-700 –EIA-232/EIA-485 Interface Interface Settings There is two interface settings located on the front panel to adapt this interface to the applications: EIA-232 Mode and EIA-485 Bus Terminator. EIA-232 Mode: Half-Duplex/Full-Duplex The EIA-232 Mode setting adapts the use of EIA-232/EIA-485 Interface to the communication driver at the EIA-232 side.
SI-700 –EIA-232/EIA-485 Interface Cabling and Applications For each application, Smar also produces a set of cables to be used accordingly. See the specifications below. Technical Specifications Number of Communication Channels Data Communication Interface EIA-232 / EIA-485 Baud rate Up to 200 Kbps enable...
SI-700 –EIA-232/EIA-485 Interface Installing the Module in the Rack Follow the steps below to install the module in the rack. Mounting a module in the rack: Find the border located at the top of the free slot. Fit the hole, at the top back of the module.
Appendix B SMAR WARRANTY CERTIFICATE SMAR guarantees its products for a period of 24 (twenty four) months, starting on the day of issuance of the invoice. The guarantee is valid regardless of the day that the product was installed. SMAR products are guaranteed against any defect originating from manufacturing, mounting,...
Page 10
13. It is the customer’s responsibility to clean and decontaminate products and accessories prior to shipping them for repair, and SMAR and its dealer reserve themselves the right to refuse the service in cases not compliant to those conditions. It is the customer’s responsibility to tell SMAR and its dealer when the product was utilized in applications that contaminate the equipment with harmful products during its handling and repair.
Need help?
Do you have a question about the SI-700-EIA-232 and is the answer not in the manual?
Questions and answers