Mapped Inputs Tab - Interlogix CDC4 Installation And Programming Manual

•
Aperio: Aperio protocol
•
SALLIS (SALTO): SALLIS protocol by SALTO systems
•
OSDP: Open Supervised Device Protocol version 2
Bus baud rate
If the Bus format is not set to ATS, the baud rate on the bus can be configured to
be one of the following:
•
4800 baud
•
9600 baud
•
19200 baud
•
38400 baud
•
57600 baud
•
115200 baud
If the Bus format is set to OSDP, then set the baud rate to 9600 baud.
If the Bus format is set to Aperio, then set the baud rate to 19200 baud.
If the Bus format is set to SALLIS (SALTO), then set the baud rate to
38400 baud.
Note: If the Bus format is set to ATS, then the baud rate is fixed at 4800 baud.
Bus encryption key
To use encryption with OSDP readers, set the 128-bit AES encryption key for the
bus. There is a 16-character limit on the key length.
The encryption key will be set on each OSDP reader attached to the bus once
the encryption key is defined.
Notes
•
Once set, the encryption key on an OSDP reader cannot be changed by
changing the encryption key for the bus. To reset the encryption key used by
an OSDP reader, the reader must be reconfigured with the appropriate OSDP
configuration card.
•
A single OSDP configuration card cannot be used twice in succession to
configure an OSDP reader. Different configuration card must be used in
between.

Mapped inputs tab

See the "Input and output mapping" section on page 66 for information on input
and output mapping.
The Mapped inputs tab shows a list of input mappings.
Click the Browse "..." button to open the Mapped input dialog to edit the selected
input mapping.
On the Mapped input dialog, click the Remove button to remove the selected
input data.
CDC4 Door Controller Installation and Programming Manual
Chapter 4: Menu reference
85