Advertisement
Quick Links
Advertisement
Summary of Contents for LAMINOX IDRO AGUA Navel 2.0 STD
- Page 1 REMOTE CONTROL Navel 2.0 STD Wi-Fi System APP INSTALLATION GUIDE...
- Page 2 WI-FI module installation 1. Connect the Wi-Fi module to the electrical network using the appropriate power supply unit provided in the kit. 2. Connect the module to the SR232 serial connector located behind the stove. Alternatively, if there is no external serial port, you can connect it directly to the circuit board via the specific connector.
- Page 3 LAMINOX REMOTE CONTROL 2.0 App Download and install the LAMINOX REMOTE CONTROL app on your device.
-
Page 4: Creating An Account
CREATING AN ACCOUNT In order to use the app, an account must be registered using the wizard described below. Each app can control multiple WiFi modules that are entered and managed via Home. This means that one account can be linked to several modules and the same account can be added to several apps so that other family members can have control on their smartphone. - Page 5 ENTERING A STOVE The app has an easy-to-understand wizard that helps you enter a desired stove and connect the module to your home WiFi in just a few steps. Press the Press EXTERNAL MODULE Make sure that everything is correctly Obtain the serial number of the stove connected and that the stove is...
- Page 6 Enter the SERIAL number found on the data label behind the stove Enter the MAC code and the REG CODE found on the USER GUIDE sheet 555555-5F Read the NOTE at the end of the page 264F28…….. Enter one of the following names according to the product you have: 123456 ARIA (Air pellet stoves and air fireplace pellet inserts)
-
Page 7: Connecting With Wi-Fi
CONNECTING WITH WI-FI After the first ADD A STOVE step, the wizard continues with module configuration by connecting it to your home Wi-Fi. Connect to T009_xxxx ATTENTION Press Once you are connected to the T009 network, go CONFIGURE VIA WIFI Don't press anything!! back to the app and press Go to your smartphone... - Page 8 Control interface Example of an interface for a IDRO stove or boiler The control interface varies depending on the model of stove or boiler.
- Page 9 Resetting the module to change the WiFi connection You can reset the module by pressing and holding the RESET button for at least 10 seconds. By doing so, the module will disconnect from the Wi-Fi network to which it was connected. After resetting, the Wi-Fi configuration procedure can be repeated again by selecting Wi-Fi CONFIGURATION from the drop-down menu.
- Page 10 APP functions in combination with the TERMOBOILER boiler Enable External Term. Use the This command can be used to Chronothermostat to remotely manage the call of a switch the boiler mechanical chronothermostat completely on and off. installed in the house. ATTENTION If this chronothermostat is set to If the boiler is switched OFF,...
-
Page 11: Troubleshooting
Troubleshooting STATU PROBLEM SOLUTION The stove is switched Connect the supplied The module is not being external power supply unit. off. powered. Make sure The module 1st Power LED power supply unit is not that the stove is being (green) connected powered. - Page 12 Laminox S.r.l. Divisione Idro Zona Industriale Callarella, 261/263 – 62028 SARNANO (MC) Italy Tel. +39 0733.657.622 – Fax +39 0733.657.494 www.laminox.com e-mail: idro@laminox.com Manual rev. 0.4...