Setting Up Set B - Dukane 8959A User Manual

Setting up Set B

1.
Turn on Set B.
• After turning on Set B, make sure the image of Set B is not
NOTE
significantly tilted compared to the image of Set A. If the image is overly
tilted, rotate the elevator feet of Set B to adjust the angle such that the tilt is
just about right. Check again that there is a gap of about 1 mm between the
protrusion at the bottom of Set B and the top of Set A.
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.
(Operating Guide
• KEYSTONE cannot be operated when PERFECT FIT is in use. To
NOTE
reset both functions, reset PERFECT FIT first.
• Perform the INSTALLATION setting first if necessary as it may change the
image position.
3.
Adjust the image size and position of Set B with the ZOOM ring, VERTICAL
adjuster, HORIZONTAL adjuster and FOCUS ring such that the image can be
superimposed well to the image of Set A.
• Fine adjustment of the image size and position thereafter with
NOTE
functions such as KEYSTONE and PERFECT FIT does not increase the
image size. It is therefore important to have the image of Set B completely
overlapping the image of Set A.
• When controlling Set B with the remote control, Set A may also respond to the
remote control. It is recommended to control Set B with the control panel on Set B.
• When two projectors are arranged side by side, adjust the image of Set B to
superimpose well to the image of Set A.
• If you are using Simple Stack, it is recommended to disable the remote
control receiving on Set B using KEY LOCK and operate using the control
panel or a wired remote control as Set A will respond to the remote control.
(Operating Guide
• If you are using Simple Stack, go to
4.
Display the menu with the MENU button.
menu function)
5.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
(Operating Guide
(continued on next page)
→ EASY MENU
(Operating Guide
→ OPTION
→ OPTION
or SETUP menu)
→ SETUP menu)
menu)
For Simple Stack
(Operating Guide
menu)
12
Installation
users. ( 16 )
→ Using the