**********ENGLISH********** CONTENTS: PURPOSE OF THE MACHINE ASSEMBLY PLACING THE UNIT INSTALLATION PERMITTED SOLVENTS PERMITTED SOLVENT DRUMS COLLECTING TRAY PREPARATIONS FOR USE OPERATING INSTRUCTIONS OPERATION WITHOUT TAP WATER CONNECTION THE COAGULATION PROCESS CHANGING THE FILTER SERVICE SAFETY INFORMATION WARRANTY TECHNICAL DATA...
PURPOSE OF THE MACHINE The machine is intended for cleaning of air-driven spray-guns that have been used for painting with water-based paint systems. The unit has two separate areas for cleaning: 1. An automatic washer (item 1 illustration 1), intended for cleaning of spray-guns with gravity fed paint-cups. In this washer water or water-based solvents can be used.
PLACING THE UNIT DRESTER BOXER DOUBLE A is equipment Category 2 (ref. ATEX-directive 94/9 EC) and may therefore be placed in locations classified as Zone 1 (ref. ATEX-directive 1999/92 EC). Make sure that the unit is properly grounded by using the grounding cable (item 6 illustration 2). This manual is part of the unit and must be available at all times.
Check for local regulations concerning max allowed volume for keeping solvents at the site of the unit Solvent drums are not provided by Hedson Technologies, thus Hedson Technologies does not take any responsibility for the drums. Follow the solvent supplier’s instructions carefully.
PREPARATIONS FOR USE Solvent drum Remove the front panel (item 5 illustration 1) by lifting it up-and-out. Remove the foot-pedal console (items 6 illustration 1) by lifting it up and folding it out to the side (see illustration 2). Place the drum to the left underneath the unit (item 2 illustration 2). Insert the group of hoses containing the drain hose from the automatic washer into this drum (item 4 illustration 2).
Page 7
the premises. Finally, the spray-gun can be blown dry by using the air-gun on the right side of the unit (item 12 illustration 1). Close the lid after cleaning.
OPERATION WITHOUT TAP-WATER CONNECTION If tap water is not available at the site of the gun-cleaner, you have the option to use recycled water (obtained from the filtering process) for the rinse-gun as well as the cleaning brush In that case the machine should be reconnected as follows: Disconnect the hose for the rinse-gun (item 1 illustration 9) from the valve-panel, remove the red plug from the cross- junction on the pump (item 2 illustration 9) and fit the hose in it´s place.
N.B.: MAKE SURE THAT YOU USE ORIGINAL DRESTER FILTERS, NR. 8701 (MAIN FILTER), AND NR. 8702 (PRIMARY FILTER). THESE FILTERS HAVE BEEN TESTED AND APPROVED BY THE PAINT MANUFACTURERS. The primary filter (item 2 illustration 11) collects most of the coagulated sludge, while the main filter (item 1 illustration 11) collects the finer paint particles.
WARRANTY Hedson Technologies AB will replace all faulty parts on the DRESTER BOXER DOUBLE S with new parts in accordance with the “Warranty Terms for Hedson Technologies AB No. 7.2-8”. This warranty only remains valid if the machine is used in the prescribed manner, and it does not cover the cost of repairs.
Page 11
Extraction capacity: 140 m3/hour (82 cfm) (with a 15 m extension) 180 m3/hour (106 cfm) (with a 5 m extension) Pump capacity: 10 l/min Solvent pressure 2 bar (30 psi) Weight 65 kg (140 lb) Overall dimensions: Height: 1510 mm (59,5”) width: 835 mm (33”) max depth: 650 mm (25,5”) depth at the floor: 610 (24”) Extractor diameter: 80 mm (7 3/16”)
Need help?
Do you have a question about the DRESTER BOXER D22A and is the answer not in the manual?
Questions and answers