11. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1. Secondary sliding sheave
2. Secondary fixed sheave
12. Install the V-belt between the secondary
sliding and fixed sheaves.
1. V-belt
13. Place the left lower cover in the original
position, and then install the screws and
the bolts. (RST1NTF / RST1NTFY).
Periodic maintenance and adjustment
RST1NTF / RST1NTFY
1
1. Left lower cover
14. Install the drive guard, and then install
the left side cover and the shroud, or
close the shroud.
ESU13926
Drive chain housing
To check the drive chain housing oil
level
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Remove the shroud and the right side
cover [RST1NTF / RST1NTFY (see page
59 for the procedures)], or open the
shroud [RST9N (see page 61 for the pro-
cedures)].
3.
Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
RST1NTF / RST1NTFY
1. Dipstick
1
81