Connection To A Tv (Progressive) - Samsung DVD-V9700 Instruction Manual

Connection to a TV (Progressive)

1
Using component video cables (not included),
connect the COMPONENT VIDEO OUT terminal
on the rear of the DVD-VCR to the
IN terminal of your TV.
2
Using the audio cables, connect from the AUDIO
OUT or LINE OUT AUDIO (red and white)
terminals on the rear of the DVD-VCR to the
AUDIO (red and white) IN terminals of your
Turn on the DVD-VCR and TV.
3
With the unit in stop mode, set the video output
P-SCAN by pressing the
front panel until the P-SCAN mode prompt screen
appears. Then press ENTER and progressive will
be output.
4
Press the input selector on your
control until the Component signal from the
DVD-VCR appears on the TV screen.
To see the progressive video output,
- Consult your TV User's Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan
settings in the TV's menu system.
- Depending on your TV, the connection method may differ from the illustration above.
Note
What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method.
Progressive scanning method provides better and clearer picture quality.
The Component Video jacks only output video from the DVD player. To view video from the VCR, you must have
the Video Out (yellow) or RF Out jack connected.
C
O N N E C T I O N S
COMPONENT
P.SCAN button on the
TV remote
White
TV.
Audio Cable
Red
ENG-17
Blue
Red Red
Green
Component Cable
(not included)
Red Blue Green
White