The Elements; Residual Heat Indicator; Operation; Main Power Switch - Bosch HIIP055U/02 Use And Care Manual

The elements

Element
Single element
/
$ Û
Flexible cooking zone
á
Only use suitable cookware for induction cooking; see section on Cooking with Induction

Residual heat indicator

The cooktop has a residual heat indicator for each
element. This indicates that an element is still hot. Do not
touch an element while the residual heat indicator is lit
up.
The following are shown depending on the amount of
residual heat:
Display : High temperature
•
▯
Display : Low temperature
œ
▯

Operation

WARNING
9
BOILOVER HAZARD
Never leave surface units unattended at high heat
settings. Boilover causes smoking and greasy
spillovers that may ignite.

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key. An acoustic signal will
sound. The __ indicator located on top of the On/Off
touch key and the symbols for the cooking zones light
up. : lights up next to the cooking zones. The cooktop
‹ ‹
is ready to use.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than 20
seconds.
The residual heat indicator remains lit until the elements
have cooled down sufficiently.
the corresponding element symbol.
Use cookware of suitable size.
See section on ~ "FlexInduction
• / œ is displayed next to
cooking zone"
®
If you remove the cookware from the element during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the element is switched off, the residual heat
indicator will light up. Even after the cooktop has been
switched off, the residual heat indicator will stay lit for as
long as the element is still warm.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys
1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by .5 in the element display and is set by
touching the symbols between the number keys.
Ú
Selecting the heat level
The cooktop must be turned on.
Select the desired element with by touching the
1.
ø symbol of the desired element. In the cooking zone
display . lights up brighter.
‹ ‹
Then select the desired power level using the number
2.
keys.
The power level is set.
3.
or
ã
15