Lea LE10100-32C1BR Original Instructions Manual page 21

2. Rear wheel adjustment (Fig.10)
Pull the rear wheel axle along the slot and lift the wheel. Then relocate it in the required
position.
Note:
1).Set the axle in the upper position for the lowest cutting height. The middle position for the
medium height and lowest position for the highest cut.
2).All wheels must be at the same position.
3).The lowest cutting height is only suitable for trimming a very level. Short lawn, High and
medium positions are recommended for normal use. Never use the mower with the wheels
set in different positions.
Power connection (Fig.11)
The mains voltage (230V) indicated on the rating plate must correspond with the mains power
supply. Mains connection fuse: min.10A.
1) Insert the mower plug into the socket of the unit connection cable.
2) To prevent the extension cord from disconnecting during use, fit the extension cord (socket
end of cord) through the loop and secure over the hook before connecting the plug.
Switching on and off. (Fig.12)
WARNING！
--Do not switch on the unit until it has been completely assembled. Before switching on the unit, always
check the connection cable for signs of damage, only undamaged connection cable may be used.
Note: Damaged connection cables are highly dangerous!
--If you try to start the lawn mower in long grass, the motor might overheat and become damaged.
Switch on: press the safety button (6) on the combined switch firstly and keep it down until pull the
switch lever (7) at one time.
Switch off: release the switch lever (7).
Note: While mowing, lay the connection cable safely on footpaths and on areas which have already
been mown.
WARNING！
When the motor has been switched off, the cutter continues running for several seconds
therefore do not touch the underside of the mower until the cutter has come to a standstill!
Mowing your lawn (Fig.13)
Select the cutting height which will suit your desired grass height. If necessary, mow in
several layers so that a maximum grass height of 4 cm will be cut in one single pass.
Make sure that you will avoid paths which could hamper free movement of the extension
cable.
Empty the grass catcher once it is full to avoid obstruction of the discharge opening. To avoid
obstruction of the discharge opening and unnecessary motor overloading, make sure that you
17