Prolights Tribe PHYRO1000D User Manual page 22

8 PHYRO1000D
2.5 OPERATION OF THE MULTI-FUNCTION CONTROL
The remote control (fig.2) allows to control different functions.
• Connect the remote control to the 5p connector on the rear panel of unit.
After the heating is completed, the green LED lights up to indicate that the machine is ready for use.
Operating mode: MANUAL (Manual), CONTINUOUS (Continuous), TIME CONTROLLED (Timer On/Off ).
When MANUAL mode is on the haze machine can be controlled by MANUAL button, press it to emit fog
and press it again to stop fog outputs (make sure that the OUTPUT knob isn't set to minimum).
When CONTINUOUS button turns on, the upper LED glows, the machine emits fog continuously until an
OFF green LED appears, indicating that it is now time to warm up again (make sure that the OUTPUT knob
isn't set to minimum).
When TIMERS button turns on, the fogging duration is adjusted by turning DURATION knob, INTERVAL
which knob sets the amount of time in between every fog output, and VOLUME knob adjusts the fog
volume. DURATION and INTERVAL knobs are effective at this moment. The LED near the button lights up
yellow when the function is active (NOTE - The fog emission will be issued after a few minutes after the
activation of the function).
2.6 WIRELESS REMOTE CONTROL
The wireless remote control system consists of a transmitter equipped with two buttons for fog output on
and off, and a receiver pre-attached to the rear panel of each PHYRO-series model.
Connect the receiver to the 5p connector on the rear panel of unit. Now you can control the machine
through the wireless remote control.
WARNING : before removing or replacing the remote control unit disconnect the power cord.
wireless receiver wireless transmitter
Wireless remote control Fig.3
Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For this
purpose, take off the housing cover and remove the used battery. Insert a fresh 12 V battery, as indicated
in the battery compartment and refit the housing cover.