Error Message - JVC LT-32DC9BH Instructions Manual

AppenDiX
(9) Channel search does not work.
- Check that your cable is connected correctly.
- Make sure that the antenna setting in the menu is correct.
- Use the appropriate antenna capable of receiving VHF or UHF channels for your area.
(0) Cannot update new software.
- You can get an update. If the TV does not show a message requesting update, that means no software is
available.
() Cannot watch pay channels.
- Check in the menu that you have a valid and working subscription to the channels you wish to view.
- Contact your network operator for more information.
() TV is turned off and on suddenly.
- If a new software is found over the air when powering the TV on or during watching a programme, the TV will
be automatically powered off and on and start to update software.
() TV does not work normally.
- Remove and insert the power plug. If this does not work, please contact your local TV distributor please
contact your local TV distributor.

error Message

Error message Possible causes
The aerial is not pointing properly.
no or Bad Signal
The channel has a signal, but no audio or video is
provided.
The channel is for data broadcasting.
The channel is
Smartcard is not plugged in.
scrambled or not
available.
Wrong Smartcard is in use.
Smartcard is not plugged in correctly.
Smartcard is damaged.
The channel has a video signal, but no audio is
Audio not available
provided.
CI Module (Conditional Access Module) is not
installed.
ci Module not
CI Module is not inserted correctly
installed.
CI Module is not recognized.
Wrong CI Module (Conditional Access Module).
invalid ci Module CI Module is not inserted correctly.
CI Module is damaged
GB-0
What to do
Adjust aerial.
Check the cable from the aerial. If you cannot resolve the
problem, you may need to have your aerial and installation
tested by a professional.
Confirm if the channel is currently on air.
The channel cannot be viewed without the appropriate
model that supports data channels.
Insert Smartcard.
Insert the appropriate Smartcard for the channel(s) you
wish to view.
Reinsert Smartcard; ensure that it is inserted correctly.
Contact your Smartcard retailer or channel broadcaster for
a Smartcard replacement.
Press the VOL+/- button on your remote control to confirm
that the channel has audio options.
Insert CI Module.
Reinsert CI Module.
Insert a different CI Module to check if your existing
module is working.
Insert the correct CI Module.
Remove and reinsert the CI Module.
Replace CI Module.