Table of Contents
Advertisement
12
STARTING COLD ENGINE
WARNING
The attachment will operate immediately when the engine starts and
could result in loss of control and possible serious injury. Keep
movable parts of the attachment off the ground and away from
objects that could become entangled or thrown.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Choke
Move choke (B) to "Cold Start" (
3. Purge bulb
Pump purge bulb (C) until fuel is visible and flows freely in the clear
fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear
of all obstacles. Firmly grasp right hand grip and throttle trigger
lockout with left hand and fully depress throttle trigger to wide
open position. Rapidly pull recoil starter handle/rope (D) until
engine fires (or maximum five [5] pulls).
5. Choke
After engine fires or five (5) pulls, move choke lever (B) back to
"Run" (
) position. Hold throttle trigger fully depressed and pull
recoil starter handle/rope until engine starts and runs. Release
throttle trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions 2 - 5.
6. Throttle
After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
DANGER
) Position.
A
B
C
D
B
Advertisement
Table of Contents
