Table of Contents
Advertisement
SAFETY & OPERATION
SAFE PRACTICES & GENERAL INFORMATION
BEFORE PULL STARTING ENGINE
•
Clear area of all people and property that could be damaged.
•
Flying projectiles from operation can cause injury.
•
Wear safety glasses, hearing protection, and gloves.
•
Do not wear loose fitting clothes that could get stuck in the moving parts of the machine.
•
Children should not run this equipment.
•
Stay alert of your surroundings and persons that could appear in the area of operation.
THIS UNIT IS A DIRECT DUAL BELT DRIVE
•
No clutch to slip or burn up, but your belts will need to be tightened and checked on a
regular basis to maintain 100% cutting power.
•
Tip the stump grinder up with the cutters off the ground when pull starting.
PERFORMANCE OPERATION
Approach the stump from the top, cutting straight down. Raise up out of the cut, move over in
the desired direction, plunge again. Repeat across the entire stump. Move side to side to base
off the stump. Adjust your bow handle for extra comfort during operation.
•
For pivot grinding, set one of your wheel brakes on using the pin provided.
•
To move the machine forward with the brake on, allow the rotating teeth against the stump
to pull the unit forward.
•
Tighten all bolts and teeth before each use. Teeth are not covered under warranty. Clean all
stones and rocks away from the operating area, check for metal stakes and or nails in the
tree stump before cutting.
NOTE: Kohler engines have a low oil shutoff to protect the engine, tilting the grinder higher
than 12 inches at an angle can cause the oil to roll back and the low oil sensor will shut the
engine off. Cut your stump 9 to 10 inches off the ground so you don't trip the sensor on the
engine.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE
BRSG105K REV A | 11
Advertisement
Table of Contents
