Advertisement
Downloaded from
ManualsNet.com
6. If there is no free slot, remove the currently installed memory module. Pull the latches
7. Remove the new memory module from its antistatic bag.
8. Hold the memory module by its edge and slide it into the memory module slot with its
9. Hold the memory module by its edge and push in until it clicks into place as shown in
10. Replace the memory module compartment cover and secure it with the screws you
11. Reattach the back panel to your computer.
12. Connect all connection cables and peripherals that you removed in Step 1, and turn on
13. Check that the amount of system memory has correctly changed.
Related Topic
search engine
in the direction of the arrows to pop up the module at an angle (1), then pull the
module out in the direction of the arrow (2).
end terminal facing downward while aligning the notch on the module with the small
projection in the slot.
If you intend to install only one memory module, be sure to install it into the lower slot.
the illustration.
The latches on both sides of the slot snap into place to secure the module. Do not
touch any ICs (black components) on the memory module.
removed in step 3.
Note
Insert the tabs of the panel in the slots, and press it down until you hear a click.
the computer.
If the amount of indicated system memory is correct, memory module installation was
successful.
312
Search
[Details]
Advertisement
