Trianco Aztec Quick Start Manual
Trianco Aztec Quick Start Manual

Trianco Aztec Quick Start Manual

Infrared panel

Advertisement

Aztec Infrared Panel
Please read these instructions carefully before installing
and operating this appliance
TO BE RETAINED BY HOUSEHOLDER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Aztec and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Trianco Aztec

  • Page 1 Aztec Infrared Panel Please read these instructions carefully before installing and operating this appliance TO BE RETAINED BY HOUSEHOLDER...
  • Page 3 HEALTH AND SAFETY INFORMATION FOR THE USER, INSTALLER AND SERVICE ENGINEER Under the Consumer Protection Act 1987 and the Health and Safety at Work Act 1974, it is a requirement to provide information on substances hazardous to health (COSHH Regulations 1998). TR Engineering takes every reasonable care to ensure that its products are designed and constructed to meet these safety requirements when the products are properly installed and used.
  • Page 4 INFORMATION The panel comes with a standard 5 Year Return to Base warranty, register online at: www.trianco.co.uk/product-registration Please note you will require the full panel serial number to be able to complete registration. What to do in the event of an appliance fault or breakdown: Step 1: Always contact your installer in the first instance, who must thoroughly check all his work PRIOR to contacting TR Engineering LTD.
  • Page 5 Operation The two-channel microprocessor temperature controller designed to control the heater, ensures comfort, efficiency, and safety. The heating is controlled by means of two temperature sensors: One controls the room temperature. The other sensor monitors the surface temperature of the heater. Once the necessary temperature in the room is set, the controller will, depending on heat losses in the room, automatically adjust the temperature of the heater, as well as the load on the electricity grid (100% or 50% of capacity).
  • Page 6 Setting the Room Temperature Press any button. C (Comfort) Appears, and the display starts flashing. Using + or – buttons adjust to desired temperature. If the button is not pressed for more than 5 seconds, the display will exit the setting mode (the value stops flashing, and the new set temperature is stored).
  • Page 7 S35 2PH Tel: (0114) 2572300 Fax: (0114) 2571419 www.trianco.co.uk © TR Engineering Limited Copyright in this brochure and the drawings and illustrations contained in it is vested in TR Engineering Limited and neither the brochure nor any part thereof may be reproduced without prior written consent.

Table of Contents