Ambient Weather OBSERVERIP 2.0 User Manual page 22

1. Remove the battery door on the back of the transmitter(s) by sliding down the battery door, as
shown in Figure 9 .
2. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of the
transmitter.
3. Channel Number: The OBSERVERIP2.0 supports up to eight transmitters. To set each
channel number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in
Figure 10.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change
Switch in down position.
Version 1.1 ©Copyright 2022, Ambient LLC. All Rights Reserved.
Figure 9
Dip Switch 4,
Switch in up position.
as referenced in
Page 22
Figure 10.