Ambient Weather OBSERVERIP 2.0 User Manual page 17

To calibrate temperature, we recommend a mercury or red spirit (fluid) thermometer. Bi-metal
(dial) and digital thermometers (from other weather stations) are not a good source and have
their own margin of error. Using a local weather station in your area is also a poor source due
to changes in location, timing (airport weather stations are only updated once per hour) and
possible calibration errors (many official weather stations are not properly installed and
calibrated).
Place the sensor in a shaded, controlled environment next to the fluid thermometer, and allow
the sensor to stabilize for 48 hours. Compare this temperature to the fluid thermometer and
adjust the OBSERVERIP2.0 receiver to match the fluid thermometer.
(2) Humidity is a difficult parameter to measure electronically and drifts over time due to
contamination. In addition, location has an adverse effect on humidity readings (installation
over
Official stations recalibrate or replace humidity sensors on a yearly basis.
manufacturing tolerances, the humidity is accurate to ± 5%. To improve this accuracy, the
indoor and outdoor humidity can be calibrated using an accurate source, such as a sling
psychrometer.
(3) The OBSERVERIP2.0 receiver displays two different pressures: absolute (measured) and
relative (corrected too sea-level).
To compare pressure conditions from one location to another, meteorologists correct pressure
to sea-level conditions. Because the air pressure decreases as you rise in altitude, the sea-level
corrected pressure (the pressure your location would be at if located at sea-level) is generally
higher than your measured pressure.
Thus, your absolute pressure may read 28.62 inHg (969 mb) at an altitude of 1000 feet (305
m), but the relative pressure is 30.00 inHg (1016 mb).
The standard sea-level pressure is 29.92 in Hg (1013 mb). This is the average sea-level
pressure around the world. Relative pressure measurements greater than 29.92 inHg (1013
mb) are considered high pressure and relative pressure measurements less than 29.92 inHg are
considered low pressure.
To determine the relative pressure for your location, locate an official reporting station near
you (the internet is the best source for real time barometer conditions, such as Weather.com or
Wunderground.com), and set your weather station to match the official reporting station.
(4) Only use this if you improperly installed the weather station sensor array and did not point the
direction
(5) The default conversion factor based on the wavelength for bright sunlight is 126.7 lux / w/m
This variable can be adjusted by photovoltaic experts based on the light wavelength of
interest, but for most weather station owners, is accurate for typical applications, such as
calculating
(6) Wind speed is the most sensitive to installation constraints. The rule of thumb for properly
installing a wind speed sensor is 4 x the distance of the tallest obstruction. For example, if
your house is 20' tall and you mount the sensor on a 5' pole:
Version 1.1 ©Copyright 2022, Ambient LLC. All Rights Reserved.
dirt vs.
reference
evapotranspiration
lawn for
to true
and solar panel
example).
Due to
north.
2.
efficiency.
Page 17