Nobile F400 -SI Mounting And Operation Instructions page 4

Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
Functions
Button
Set brightness level of the light during occupancy
BRIGHTNESS
Set Presence sensor sensitivity
SENSITIVITY
Length of time before the lamp goes to Stand-by
mode when no presence is detected
HOLD TIME
15min / 20 min / 30 min / 60 min)
To enter daylight sensor configuration
Sets lamp to permanent On or Off and disable the
sensors (to quit this mode, press the Auto button)
LED indicator will display the set parameters
Navigation keys up and down during parameters
Fernbedienung für Präsenzmelder F400-SI
Remote control for LED High Bay F400 -SI
Description
(70% / 80% / 90% / 100%)
(20% / 50% / 75% / 100%)
(10sec / 1min / 5min / 10min /
(disabbled by default)
setting
Confirmation button
Preset scene modes
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
Button
Set brightness level of the light during
STAND-BY
DIM
(0% / 10% / 30% / 50%)
To enter Presence sensor sensitivity test mode:
hold time is 2sec, Standby time and Daylight
sensors are deactivated
(to quit this mode, press the Auto button)
Length of time that the lamp stays in Stand-by
STAND-BY mode before it switch Off when no presence is
TIME
(+∞ / 1min / 30min / 60 min)
DAYLIGHT
Daylight level threshold of the sensor
SENSOR
Select the surrounding lux value as the daylight
Deactivate the upper threshold of the daylight
Daylight sensor lower threshold (lux Set-point On)
Daylight sensor upper threshold (lux Set-point Off)
To enable the sensors and all previously set
parameters prior permanent On/Off
Reset parameters to the dip switch sensor setting
Navigation keys left and right during parameters
Upload the set parameters to the sensor
(During uploading, aim the remote at the target
sensor. The lamp connected to the sensor will blink
rev. 0.1 – 03.05.2022
Seite 4 von 4
Description
non-occupancy
detected
threshold
sensor
setting
to confirm sending)