Advertisement
Available languages
Available languages
Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
EN
Congratulations on your purchase of this nobilé-product!
You have decided on a high-quality product which is manufactured with the utmost care and subject to several quality controls. Safe use of the
product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these instructions the warranty
expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance with existing standards and
local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation, make sure any component of the
entire installation does not bear a risk of life. According to common practice, please perform a standard function test, before installing. To make
maintenance work possible, the lighting system should be accessible after installation (auditable).
Technical Specification
Battery
Operation Frequency
Transmission Power
Sending Range
Ambient Temperature Ta
Dimension
Warning!
Remove the batteries from the device when the remote will not be use in 30 days.
Motion Sensor
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
Daylight Sensor
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
Mode Settings
Application
Mode
Indoor
Mode 1
Indoor
Mode 2
Indoor
Mode 3
Outdoor
Mode 4
Fernbedienung für Präsenzmelder F400-SI
Remote control for LED High Bay F400 -SI
2 x AAA
5.8GHz 75MHz
<0.2mW
max. 15m
0 ~ 50°C
123 x 70 x 20 mm
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
Brightness
Sensitivity
100%
75%
100%
75%
100%
75%
100%
75%
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
After the set Hold-time, the lamp
will dim down to the set Stand-by
level when no presence detected
Hold Time
Stand-by Time
5 minutes
30 minutes
1 minute
+∞
5 minutes
30 minutes
1 minute
+∞
rev. 0.1 – 03.05.2022
Seite 3 von 4
The
lamp
will
switches
automatically after the Stand-by
time elapses
Stand-by Level
Daylight Sensor
30%
30%
30%
30 Lux
30%
(30 Lux / 300 Lux)
off
Advertisement
