Advertisement
Troubleshooting
Problem
Drone will not
bind with
and turn on the controller while holding down the bind button located at the
controller
LED on compass
is not blue
Drone will not
Using the micro-USB port on the side of the Pixhawk 4 mounted on the top
arm
Safety Protocols
• All drones should be operated by a licensed drone operator and should follow local and
federal regulations during operations.
• Stay at least 10 feet away from the drone while arming and during flight.
• Do not fly in inclement weather
• Ensure the battery is fully charged before flight to avoid a crash landing.
Operational Limitations
All drones should only be operated by a licensed drone pilot, in a safe location, and not during
inclement weather.
This drone was designed to comply with FAR 107 regulations. For more information regarding
the FAR 107 regulations visit the FAA website by clicking on the link below
FAR 107 regulations via the FAA website:
Small Unmanned Aircraft Systems (UAS) Regulations (Part 107) | Federal Aviation
Administration (faa.gov)
Unplug the drone and turn off the controller. Then plug the drone back in
Wait 2 minutes for the GPS to acquire a signal.
of the drone, connect to a computer and recalibrate the compass using the
QGroundControl software and following the steps on the screen.
Solution
top of the controller.
Advertisement
