Page 1
USER MANUAL Quick Start Guide Pixhawk Flight Controller Motor Drone arm Propeller Drone Body Safety Warnings ● All drones should be operated by a licensed drone operator and should follow local and federal regulations during operations. ● Stay at least 10 feet away from the drone while arming and during flight. ●...
Page 2
Controller Layout A - Arming Switch B - Flight Mode Select Switch C - Throttle/Yaw Stick D - Power Button E - Display F - Pitch/Roll Stick...
Page 3
STEP 1 The first step in setting up the drone is to plug the battery into the drone. This is done by connecting the female connector on the drone to the male connector on the battery as shown above. STEP 3 After the controller is turned on the controller and the drone receiver should automatically bind.
Page 4
STEP 4 The controller should be placed into flight mode 3 before takeoff. The current flight mode will be displayed on the screen (above left). To ensure this make sure that switch “B” is in position “2” (right). STEP 5 STEP 6 Next make sure the drone is ready To arm the drone put switch “A”...
Troubleshooting Problem Solution Drone will not Unplug the drone and turn off the controller. Then plug the drone back in bind with and turn on the controller while holding down the bind button located at the controller top of the controller. LED on compass Wait 2 minutes for the GPS to acquire a signal.