RUSTA 156500110101 Manual page 5

USE
• Connect the end of the hose with the flexible conduit adapter to the air pump inflation
inlet (13), and twist clockwise to tighten it, as in Figure 1.
• Connect the other end of the hose to the supporting air tap of the air bag, and
twist clockwise to tighten it. Then insert the inflation valve of the air bag and twist
clockwise to tighten it, as in Figure 2.
• Plug the DC plug into the 12V DC socket.
• Press the pressure unit toggle button
• Press the pressurising button
value you need, with a range of pressure value from 0 to 16PSI (1PSI=0.0689BAR)
• After finishing the above steps, press the power switch button
• During the inflating process, you can press the pressurising button
decompressing button
pressure unit toggle button
to stop .
• When the pressure reaches the set value, the air pump will stop working
automatically.
• After completing the inflation, pull out the DC plug from the 12V DC socket.
• After pulling out the DC plug, please remove the hose from the air pump and air bag
and store it safely.
• ATTENTION! The factory set pressure value for the air pump is 10PSI
(10PSI=0.689BAR). When in secondary use, the set pressure value from the last time
it was used will be displayed by default.
• ATTENTION! After powering on, if there is no operation within 2 minutes, the air
pump will enter standby mode, and the machine can be initiated by pressing the
power switch button
or decompressing button
to increase or reduce the pressure value. Press the
to switch the unit, and press the On/Off button
.
Fig. 1
to select the unit you need.
to set the pressure
to start inflation.
or
Fig. 2
5