Troubleshooting - Pyle PKRK270BT User Manual

Troubleshooting

Refer to the table below for a few common problems and how to solve them.
If you are still experiencing issues, contact Customer Service for assistance.
Failure
Not turning ON
No image
No sound
Can't play the disk
Remote control
doesn't work
Poor image
Not working properly
Unable to connect
to Wireless BT
Can't play les from
USB
22
www.PyleUSA.com
• Check whether the power cord is connected to a suitable
power outlet and turned on.
• Check if the ON/OFF switch on the rear of the unit is set to
the ON position.
• Check whether the player is properly connected to the TV;
• Check whether the TV works well;
• Adjust the Video mode setting on the TV until image is
displayed correctly.
• Check whether the player is properly connected to other
equipment.
Check if the audio cables have been connected properly
and the correct mode has been chosen.
Check whether the disk is properly inserted; Clean the disk.
• Remove the barrier between the remote control and the
device;
• Point the remote control to the IR receiver on the front
panel (near the disk door).
• Try replacing the batteries in the remote control.
• Check whether the disk is dirty or scratched;
• Clean the disk or replace it;
• Turn o the unit and restart it after a few seconds.
Turn o the unit and restart it after a few seconds.
• Make sure there are no obstacles between the unit and
your device. Move closer to the unit during pairing.
• Try clearing the list of BT devices from your smartphone
or tablet.
• Check if the le is in a compatible format.
Only jpeg, avi, wma and mp3 les can be played.
• Remove any disc from the disc tray. USB les can be played
only when there is no disc in the disc tray.
Solution